HP Photosmart C6200 All-in-One Série Guide D'utilisation page 14

Chapter 2
NOTE:
active network, otherwise the setting will not stay when you exit from the menu.
CAUTION:
IP address during the installation, your network components will not be able to connect
with the HP All-in-One.
1. Press Setup.
2. Press
The Network Menu appears.
3. Press
4. Press
If the HP All-in-One is already connected to a wired network, you are prompted to
confirm that you want to change the IP settings. Press OK.
5. Press
6. Press
• IP Address
• Subnet Mask
• Default Gateway
7. Enter your changes, and then press OK to confirm the setting.
14 HP Photosmart C6200 All-in-One series
When manually entering an IP setting, you must already be connected to an
Be careful when manually assigning an IP address. If you enter an invalid
until Network is highlighted, then press OK.
until Advanced Setup is highlighted, and then press OK.
until IP Settings is highlighted, and then press OK.
until Manual is highlighted, and then press OK.
to highlight one of the following IP settings, and then press OK.