Resetting To The Factory Default Settings; Further Information - Axis 231D+ Guide D'installation

Page 12
Accessing the AXIS 231D+/232D+ from the Internet
Once installed, your AXIS 231D+/232D+ is accessible on your local network (LAN). To access the camera from the
Internet, network routers must be configured to allow incoming traffic, which is usually done on a specific port.
Please refer to the documentation for your router for further instructions.
For more information on this and other topics, please visit the Axis Support Web at www.axis.com/techsup

Resetting to the Factory Default Settings

This will reset all parameters, including the IP address, to the factory default settings:
1. Disconnect power from the camera.
2. Press and hold the Control button and reconnect power.
3. Keep the Control button pressed until the Status indicator displays amber (this may take up to 15 seconds),
then release the button.
4. When the Status indicator displays green (which can take up to 1 minute) the process is complete and the
camera has been reset.
5. Re-assign the IP address, using one of the methods described in this document.
It is also possible to reset parameters to the original factory default settings via the web interface. For more
information, please see the online help or the user's manual.

Further information

The user's manual is available from the Axis Web site at www.axis.com or from the Axis Network Video Product CD
supplied with this product.
Tip!
Visit www.axis.com/techsup to check if there is updated firmware available for your AXIS 231D+/232D+. To
see the currently installed firmware version, see the Basic Configuration web page in the product's Setup tools.
AXIS 231D+/232D+ Installation Guide