Emerson Appleton AA-51 LED Serie Mode D'emploi page 3

SHORT BRACKET INSTALLATION
1. Remove threaded adapter from junction box for
easier access to conduit system.
2. Remove VPT-7 Connection Block from threaded
adapter.Pull supply wire (110°C minimum) into
junction box.
3. Replace threaded adapter and secure set screw.
4. Connect supply wires to appropriate "black" wire
and "white" wire on VPT-7 block per installation
instructions.
5. Push VPT-7 connector block into place and tighten
screws. Install fixture unit.
• Remove unused conduit plug and reinstall
with pipe sealant.
FIGURE 2
TLC-3 LUBRICANT
SHOULD BE APPLIED
TO ALL THREADS
SET SCREW
GROUNDING
SCREW
Appleton • 1.800.621.1506 • www.appletonelec.com
AASB-50/75
15° SHORT
BRACKET
59064050000
THREADED ADAPTER
VPT-7 CONNECTOR BLOCK
SCREW #8 -32 x 1/2" PH. HD.
ALL GRIME AND GRIT MUST BE
REMOVED FROM GROUND
SURFACES OF FIXTURE BODY AND
GLOBE CONTACT POINTS.
ALSO APPLY TLC-3 LUBRICANT
TO GLOBE RING THREADS.
STANDARD PORCELAIN REFLECTOR
FIGURE 3
AA-51 LED FIXTURE SHOWN WITH
CEILING MOUNTING HOOD
GREEN GROUNDING SCREW
TLC-3 LUBRICANT
BOTTOM LOCKING
SPRING WITH SCREW
#8-32 x 1/4" RD. HD.
IMPORTANT NOTE
AAGUA-15
ALUMINUM GUARD
AARW-15ST
JUNCTION BOX
Four hubs and
three close-up plugs
59064050000
THREADED ADAPTER
SLOTTED SET SCREW
1/4" - 20 x 3/8"
590640849
FIBER GASKET
VPT-7
CONNECTOR BLOCK
SCREWS (2)
#8 -32 x 1/2" PH. HD.
FIXTURE BODY
TLC-3 LUBRICANT
REFLECTOR MOUNTING
SCREWS (3)
# 8-32 x 3/8" RD. HD.
GLOBE AND RING ASSEMBLY
AAGUA-15
650592-000 Rev. B 07/17/18 • Page 3 of 8