MALONE BigFoot MPG112 Instructions page 4

Installation & Loading Instructions - MPG112MD BigFoot
4
. Place the canoe on the gunwale brackets. Adjust the
canoe and brackets until they are centered in the middle
of the roof and the canoe is evenly balanced. With the
brackets fitted against the canoe, firmly tighten the
T-knobs on all four brackets.
See image 5.
6
. Pull the free end of the strap loop down until the buckle
is approximately half-way up the side of the canoe.
Dress the free end under the cross rail.
See image 7.
MALONE
Instructions - Installation et chargement
. Install the three remaining gunwale brackets according to
. Dress the free end of a strap under the cross rail. Pull the
free end up and out until an even loop is created. Place the
loop up and over the canoe. See image 6.
steps 1-3. Note: Do not tighten the T-knobs. The brackets
should be left loose so they can be centered in step 5.
See image 4.
5
7
R
TM