Connect Ductwork - Best Powerpack Inserts HBN1 Serie Instructions D'installation, D'utilisation Et D'entretien

INSTALL THE UNIT (
H
ORIZONTAL EXHAUST INSTALLATION ONLY
6. Reinstall and secure the faceplate to the unit using its
4 retaining screws (two per side, circled in FIG. 28). Plug
the blower cable to its connector on faceplate (FIG. 28).

CONNECT DUCTWORK

V
ERTICAL EXHAUST INSTALLATION ONLY
Ducted Installation
Use 6-in. round, 8-in. round or 3¼" x 10" metal duct to
connect the adapter damper on the top of the unit to the
ductwork above (FIG. 29, 8-in. round not shown). Seal
the joint using aluminum duct tape.
Non-Ducted Installation
A non-duct kit is required for this type of installation
(purchase separately). To install, follow the instructions
packed with the kit. Refer to table below to find the
appropriate non-duct kit according to the unit.
Unit model
HBN1246SS
HBN1306SS
14
' )
CONT D
( ' )
CONT D
Non-Duct kit model
HARKBN24
HARKBN30
FIG. 28
FIG. 29