Quick TCD Série Mode D'emploi Et D'installation page 19

REMOTE CONTROL ENABLING
To enable the remote control, press the enabling button and keep it pressed for at least 1 second.
After this period the enablement LEDs will start fl ashing with greater frequency and the control will emit a short
sound.
Release the enablement button, the enablement LEDs will remain steadily lit on and the remote control will be
enabled. In this condition the control will emit a short sound every 5 seconds.
THRUSTER ACTIVATION
Bow thruster activation
When the propeller is activated the direction led corresponding to the imparted movement (red to the left, green
to the right) will light on and the control will emit an intermittent sound.
WARNING: once the direction button (TCD 1022) or the joystick (TCD 1042) has been released, the boat
will continue to move according to the inertia of the movement.
STERN THRUSTER ACTIVATION
Because of the space limits of the bow, some boats only have a stern thruster.
In this case, this thruster will be used in the same way as that for the bow thruster.
(see Bow thruster activation paragraph).
TCD1022 D/1042 D - REV004A
OPERATING
• To move the bow to the right, keep the right di-
rection button (TCD 1022) pressed down, or move
the joystick (TCD 1042) to the right at the end of its
stroke.
• To move the bow to the left, keep the left direc-
tion button (TCD 1022) pressed down, or move
the joystick (TCD 1042) to the left at the end of its
stroke.
GB
19