Power Cord - Power Fist 2/12/75 A Manuel D'utilisateur

Démarreur/chargeur de batterie
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

V 4.0
7.
Make certain the power source conforms to requirements of your
equipment (see Specifications).
8.
Grounded tools must be plugged into an outlet that is properly installed and
grounded in accordance with all codes and ordinances. Check with a qualified
electrician if you are in doubt as to whether the outlet is properly grounded. If
the tool should electronically malfunction or break down, grounding provides a
low resistance path to carry electricity away from the user.
a.
Never remove the grounding prong or modify the plug in any way, as
this will render the tool unsafe.
b.
Do not use any adapter plugs.
9.
This device is only for use on 120 V (single phase) and is equipped with a
3-prong grounded power supply cord and plug.
10. DO NOT use this device with a 2-prong wall receptacle.
a.
Choose an available 3-prong power outlet.
b.
Replace 2 prong outlet with a grounded 3-prong receptacle, installed
in accordance with the CE Code and local codes and ordinances.
11. Do not operate unit with damaged cord or plug; or if the unit has received a
sharp blow, been dropped, or otherwise damaged in any way. Do not
disassemble the unit; incorrect reassembly may result in a risk of electric
shock or fire.
WARNING! All wiring should be performed by a qualified electrician.

POWER CORD

1.
Insert the power cord plug directly to the power supply whenever possible.
Use extension cords or surge protectors only when the tool's power cord
cannot reach a power supply from the work area.
a.
When operating a power tool outside, use an outdoor extension cord
marked W-A or W. These cords are rated for outdoor use and reduce
the risk of electric shock.
b.
Use in conjunction with a Ground Fault Circuit Interrupter (GFCI). If
operating a power tool in a damp location is unavoidable, the use of a
GFCI reduces the risk of electric shock. It is recommended that the
GFCI should have a rated residual current of 30 mA or less.
2.
Do not operate this tool if the power cord is frayed or damaged as an electric
shock or surge may occur, resulting in personal injury or property damage.
Visit www.princessauto.com for more information
2/12/75A Battery Charger/Starter
8646077
5

Publicité

Table des Matières
loading

Table des Matières