Power Fist 2/12/75 A Manuel D'utilisateur page 13

V 4.0
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Problem(s)
No reading on
the ammeter.
Ammeter
readings stays
high.
Charger will not
turn on when
properly
connected.
The battery is
connected and
the charger is on,
but is not
charging.
Visit www.princessauto.com for more information
2/12/75A Battery Charger/Starter
Possible Cause(s)
1. Charger is not
plugged in.
2. No power at the
receptacle.
3. Clips have a poor
connection to the
battery.
4. Connections are
reversed.
5. Battery is defective
(will not accept a
charge).
6. 2 amp charge rate
is being used.
1. Battery is severely
discharged.
2. Wrong battery
voltage.
1. AC outlet is dead.
2. Poor electrical
connection.
Clips are not making a
good connection.
Suggested Solution(s)
1. Plug the charger into an AC outlet.
2. Check for open fuse or circuit breaker
supplying AC outlet.
3. Check for poor connection to battery
and frame. Make sure connection
points are clean. Rock clips back and
forth for a better connection.
4. Unplug the charger and reverse the
clips.
5. Have battery checked.
6. Ammeter may show no activity at the
2A charge rate.
1. Continue charging battery for two more
hours.
2. If problem continues have the battery
checked.
3. Verify the voltage settings or output
ratings on the charger are correct.
1. Check for open fuse or circuit breaker
supplying AC outlet.
2. Check power cord and extension cord
for loose fitting plug.
Check for poor connection at battery and
frame. Make sure connecting points are
clean. Rock clips back and forth for a
better connection.
8646077
13