Care & Maintenance; Battery Maintenance - Power Fist 2/12/75 A Manuel D'utilisateur

V 4.0
6. Once the engine starts, unplug the AC power cord, then disconnect the
battery clips from the vehicle battery and frame.
a. Allow the engine to run for 10 to 15 minutes to recharge the battery.
7. Clean and store the charger in a dry location.
8. If the engine does turn over, but never starts, the problem is not with the
starting system. Resolve the other issues before cranking the engine again.
CARE & MAINTENANCE
1. Do not open the unit, as there are no user-serviceable parts. All servicing
should be performed by a qualified technician.
2. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
3. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
4. Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd.
for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.

BATTERY MAINTENANCE

1. Charge batteries in a designated, well-ventilated area to avoid gas buildup.
2. Charge the battery at rates recommended by the manufacturer.
3. Disconnect the charger from its power source before attaching or
removing the clamp connections.
4. Carefully attach the clamps to the battery terminals based on their
proper polarity.
5. Maintain the connections and the vent plug adjustment per the
manufacture's recommendations. Also maintain the vent caps to reduce
the chance of electrolyte spray.
6. Clean the terminals and rinse off the battery's outer surface before
recharging. Brush away from yourself when cleaning debris from the
battery and terminals to avoid potential contamination.
Visit www.princessauto.com for more information
2/12/75A Battery Charger/Starter 8646077
11