Reset To Factory Default Settings - Axis P3905-RE Guide D'installation

AXIS P3905–RE Network Camera
10. Remove and discard the protection tape from the glass (top
cover outside).
Access the Product
Use the tools provided on the Installation and Management Software
CD to assign an IP address, set the password and access the video
stream. This information is also available from the support pages on
www.axis.com/techsup/

Reset to Factory Default Settings

Important
Reset to factory default should be used with caution. A reset to
factory default will reset all settings, including the IP address,
to the factory default values.
Note
The installation and management software tools are available on
the CD supplied with the product and from the support pages on
www.axis.com/techsup
To reset the product to the factory default settings:
1. Disconnect power from the product.
2. Press and hold the control button and reconnect power. See
Hardware Overview on page 8 .
5
16
3.
5.
1.
6.
2.
4.