Reset To Factory Default Settings - Axis Q8685-EPTZ Mode D'emploi

Reset to factory default settings

CAUTION
Risk of injury. Moving parts. Keep your body parts away from the product when in
operation. Disconnect from power supply before installing or performing maintenance
on the product.
CAUTION
Risk of injury. Hot surface. Do not touch the product when in operation. Disconnect
from power supply and allow the surfaces to cool before performing maintenance on
the product.
Important
Reset to factory default should be used with caution. A reset to factory default will reset
all settings, including the IP address, to the factory default values.
Note
The installation and management software tools are available from the support pages on
www.axis.com/support/downloads
To reset the product to the factory default settings:
1. Disconnect power from the product.
2. Remove the four top cover screws and remove the top cover.
3. Change the position of the Factory default switch, see Hardware overview on page 18.
4. Replace the top cover and tighten the screws (torque 3.0 Nm).
5. Re-connect power to the product.
It is also possible to reset parameters to factory default via the web interface.
AXIS Q8685-E PTZ Network Camera
47
EN