Electrical Connection - Amana AMAP081AW Guide D'utilisation Et D'entretien

Assemble Vent Hose
1.
Assemble vent hose
Vent hose
Round
connector
Extend both ends of the vent hose a little bit.
Thread a round connector clockwise onto one end of the vent
hose. Thread a window connector clockwise onto the other end
of the vent hose.
2.
Attach vent hose to air conditioner
Slide the round connector into the exhaust port on the back of
the air conditioner from right to left.
3.
Lock vent hose in place
Press the lock switch to the right to be sure the connector is
locked in place.
6
4.
Attach vent hose to slider panel
Window
connector
Position the air conditioner in the desired location.
Extend the vent hose enough to reach from the air conditoner
to the window. Be sure there are no sharp bends or kinks in the
hose.
Press the window connector end of the vent hose into the
opening on the slider panel as shown. It will clip into place.
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1.
Plug into grounded 3-prong outlet
Plug into a grounded 3-prong outlet
Press the RESET button on the power supply cord.
See "Electrical Requirements."
Slider panel

Electrical Connection

WARNING
Electrical Shock Hazard
Window
connector