Replacing The Lamp Unit - Panasonic PT-52LCX66-K Manuel D'utilisation

Replacing the lamp unit

The lamp unit is sold separately. To purchase
a replacement, call the Panasonic accessory
department, toll free at: 1-800-332-5368 (USA only).
In Canada call 905-624-5505.
Lamp unit Part No. : TY-LA1001-K
Lamp unit replacement period
The Lamp is a consumable item and it's life varies based
on individual usage. Panasonic warranties the original
Lamp for a period of 90 (ninety) days from the date of
purchase. Replacing the lamp is so easy that you can do
it yourself. For the lamp replacement procedure, please
see the next page.
• The unit will detect when the
Lamp's end of life is approaching
and the message (shown at right)
will be displayed.
• The LAMP indicator light will be
lit when the Lamp's end of life is
approaching.
Influences of frequent lighting, continuous light use for
over 24 hours, the number of times lit, the length of
time between lightings, etc. may shorten lamp life.
(Because of this, we recommend having a replacement
lamp on hand.)
WARNING
Failure to follow these warnings when replacing the
lamp unit could result in personal injury:
1) The lamp could rupture if dropped and lamp
fragments could cause injury.
2) Because the lamp unit is hot immediately after its
use, touching it may cause burns.
Please allow the lamp to cool before handling or
replacing the lamp unit.
3) If replacement of the lamp unit becomes necessary
during the operation of the Projection Display, follow
the procedure below.
a. Press the POWER button on the Remote Control to
turn off the power.
b. Wait for about 1 minute until the cooling fan stops.
• The lamp cooling fan will continue to operate for
about 1 minute after turning off the power. Do not
unplug the power cord from the outlet until the fan
has stopped. Avoid interrupting the power line by
using circuit breakers or switchable power strips.
c. After the cooling fan has stopped, Disconnect the
power cord from the outlet.
d. Please wait more than one hour to let the lamp cool
before replacing it.
e. [If you need to replace the lamp more urgently]
• The Projection Display has a forced cooling feature.
After the POWER button is turned OFF, and during the
first minute of the normal cooling fan operation, press
the VOL+ button on the Projection Display and the ▲
button on the Remote Control at same time for more
than 5 seconds. The cooling fan operates for about
10 minutes. The LAMP indicator flashes red 5 times
every 5 seconds.
64
Because of the possibility of injury, strictly follow
the replacement procedure on the next page.
This product has a High Intensity Discharge (HID)
lamp that contains a small amount of mercury.
Disposal of these materials may be regulated in your
community due to environmental considerations.
For disposal or recycling information please contact
your local authorities, or the Electronics Industries
Alliance: <http://www.eiae.org.>
The lamp needs to be
replaced, and the lamp
hour meter needs to be
reset.
Lamp replacement procedure
1
CAUTION
Turn power off, wait until power indicator stops
blinking red, then disconnect the power cord
from the wall outlet and confirm that the area
around the lamp unit has cooled down.
POWER button/
LAMP indicator
POWER indicator
• Please wait more than one hour for lamp replacement.
If you need to replace the lamp more urgently, please
see "e" at left.