Table des Matières
Publicité
OPERATING INSTRUCTIONS
USING THE SPRAY BUTTON
For a mist of water to moisten dry and difficult fabrics such as linen,
cotton or wool, or to handle stubborn wrinkles, press the Spray Button.
The Spray Function is also handy to moisten creases accidentally
ironed into the fabric.
NOTE: You may have to pump the Spray Button several times
the first time your use the Iron in order to start the spraying
action.
FILLING THE WATER TANK
1. Unplug the Iron before filling.
2. Turn the Variable Steam Dial to
3. Hold the Iron in horizontal position (Soleplate down).
4. Using a measuring cup, slowly pour water into the Water Tank
Opening.
5. Check see-through Water Tank to see if Iron is filled to MAX Fill
Mark.
NOTE: Your Iron is designed to use tap water. However, if your water
is very hard, it is recommended that you use distilled water. DO NOT
use water from home water softening systems because such water may
contain minerals that may harm the Iron.
CAUTION: Never fill Iron with fabric conditioner, starches, or any
other solution as these will damage the steam mechanism. Do not
use contaminated water.
EMPTYING THE WATER TANK
The Water Tank should be emptied after each use.
1. Unplug Iron from the electrical outlet.
2. While the Iron is still warm, hold the Iron over a sink and allow the
Iron to drain by tipping the point of the Iron down.
3. Gently shake the Iron to loosen any water drops that may be
trapped. The warmth of the Iron should dry out any remaining
water.
NOTE: If you empty the Water Tank after the Iron has cooled, set
the Iron in an upright position on its Heel. Plug it in and set the
Temperature Control Dial to MAX heat for 2 minutes. Then unplug
the Iron and let it cool before storing.
(Cont.)
NO STEAM setting.
8
Publicité
Table des Matières
