Ironing With Steam - Westinghouse WST5002ZE Manuel Du Propriétaire

OPERATING INSTRUCTIONS

IRONING WITH STEAM

When using as a Steam Iron, be sure the temperature setting on the
Temperature Control Dial is within the WOOL; COTTON; or LINEN set-
ting to avoid water spotting on a garment.
1. Position Temperature Control Dial to the lowest MIN setting.
2. With the unit UNPLUGGED, fill the Iron's Water Tank to the MAX
Fill Mark.
3. Stand the Iron on its Heel in an upright position on an iron-safe
surface and plug it into a 120V AC outlet.
4. Turn the Temperature Control Dial to the WOOL; COTTON; or
LINEN setting.
5. Allow approximately 2 minutes for the Iron to reach the desired
temperature.
6. Turn the Variable Steam Dial to
for Maximum Steam. As soon as the Iron is held horizontally, steam
will flow through the Vents. If the iron fails to steam, gently tap the
Soleplate on the Iron surface. Placing the Iron on its Heel in an
upright position interrupts the flow of steam.
7. When finished, turn the Temperature Control Dial to MIN and
unplug. Allow Iron to cool fully before cleaning the exterior of the
Iron or before storing.
CAUTION: Avoid coming into contact with escaping steam.
CAUTION: If the Iron has been used for a long period of time
and is hot, DO NOT fill it with water. Allow to cool, then refill
and resume ironing.
BLAST OF STEAM
The "Blast of Steam" is very useful for removing stubborn creases from
fabrics.
1. Fill Water Tank and set Temperature Control Dial to either the
WOOL; COTTON; or LINEN setting.
2. Press down on the Blast of Steam
NOTE: If the temperature setting is too low, water may drip from
Soleplate. To obtain a good flow of steam, press Blast of Steam Button
several times, pausing 5 seconds between each blast to allow Iron to
reheat.
(Cont.)
for Moderate Steam or
Button.
7