Ironing Without Steam - Westinghouse WST5002ZE Manuel Du Propriétaire

OPERATING INSTRUCTIONS
FOR BEST RESULTS
3. If you are unsure of a garment's fabric content, start on a low
setting and test the Iron on an area of the garment that does not
show, such as a seam. Gradually increase the heat setting until
wrinkles remove without damaging the fabric.
4. To prevent shine, iron dark garments, or those made of silk,
acetate or rayon, inside out.
WARNING: To prevent fire, do not leave Iron unattended
while plugged in.

IRONING WITHOUT STEAM

The Iron can be used with or without water in the Tank. However, it is
best to avoid having the Tank too full of water while ironing without
steam.
1. Position Temperature Control Dial to the lowest MIN setting.
2. Turn the Variable Steam Dial to
3. Stand the Iron on its Heel in an upright position on an iron-safe
surface and plug into a 120V AC outlet.
4. Turn the Temperature Control Dial to the desired setting.
5. When the Heating/Ready Light turns off, the Iron has reached the
desired temperature.
6. If desired, you may still use the Spray Button or Blast of Steam
Button as long as there is water in the Tank.
7. When finished, turn Temperature Control Dial to the lowest MIN
setting and unplug. Allow the Iron to cool before cleaning the
exterior or before storing.
NOTE: During ironing, the Heating/Ready Light may turn on
again which indicates that the Iron is heating up to maintain
the proper temperature.
CAUTION: If the Iron has been used for a long period of time
and is hot, DO NOT fill it with water.
(Cont.)
NO STEAM.
6
(Cont.)