Burnishing With 2550 Model - Tennant 2510 Manuel

OPERATION
3. Begin burnishing by pushing machine forward.
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
4. Adjust pad pressure meter within Green Zone.
Press the pad pressure switch to decrease or
increase pressure. For best results adjust needle
as shown (Figure 11).
GREEN
ZONE
ATTENTION: Do not operate machine in red zone,
floor damage and brush motor overload may
result.
NOTE: If machine vibrates, realign pad.
ATTENTION: Keep machine moving at all times to
prevent floor damage.
5. To stop burnishing, release grips. The pad will
automatically raise to the transport position.

BURNISHING WITH 2550 MODEL

1. Release parking brake lever, if equipped.
2. Turn on key, if equipped, then turn on main power
and pad switches.
3. Turn speed control knob to slowest speed. This
will prevent an abrupt take off (Figure 12).
4. Twist control grips forward to begin burnishing.
Gradually turn speed control knob to desired
cleaning speed (Figure 13).
10
Meter Needle
RED
ZONE
FIG. 11
FIG. 12
Home Find... Go To..
FIG. 13
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
5. Adjust pad pressure meter within Green Zone.
Press the pad pressure switch to decrease or
increase pressure. For best results adjust needle
as shown (Figure 14).
GREEN
ZONE
FIG. 14
ATTENTION: Do not operate machine in red zone,
floor damage and brush motor overload may
result.
NOTE: If machine vibrates, realign pad.
ATTENTION: Keep machine moving at all times to
prevent floor damage.
6. To operate machine in reverse, simply pull reverse
trigger, one speed (Figure 15).
FIG. 15
7. To stop machine, release grips. The pad will
automatically raise to the transport position.
Meter Needle
RED
ZONE
Tennant 2510/2550 (08- -08)