Turning The Tv On And Off; Memorizing The Channels - Samsung PN42B400P3D Guide De Configuration Rapide

Turning the TV On and Off

Press the POWER button on the remote control.
You can also use the POWER button on the TV.
➢ It may take a while for the picture to appear.
Viewing the Displays and Menus
Viewing the Display
Press theINFO button on the remote control.
The TV will display the channel, the type of sound,
and the status of certain picture and sound settings.
TV #1
DTV Air Dolby Digital Fri, Dec 19 2:05 am
13-1
M. Spillane's Mike Hammer
Bonocrunch
Prison Break
Next Program
Viewing the Menus
With the power on, press the MENU button.
The main menu appears on the screen. The menu's
left side has icons: Picture, Sound, Channel,
Setup, Input, Support.
Mode
Cell Light
Contrast
Brightness
Sharpness
Color
Tint (G/R)
Press the ▲ or ▼ button to select one of the icons.
Then press the ENTERE button to access the
icon's sub-menu.
Press the EXIT button to exit.
➢ It takes about one minute until the on-screen
menu disappears.
BN68-02444A.indb 7
1080i 16:9 English
1:55 am - 2:55 am
2:55 am - 3:55 m
: Standard
: 4
: 95
: 45
: 50
: 50
: G50/R50
English - 7

Memorizing the Channels

Your TV can memorize and store all of the available channels
for both air and cable channels. After the available channels
are memorized, use the CH or CH
through the channels. This eliminates the need to change
channels by entering the channel digits. There are three
steps for memorizing channels: selecting a broadcast source,
memorizing the channels (automatic) and adding and deleting
channels (Channel Lists).
Storing Channels in Memory
(Automatic Method)
Before your television can begin memorizing the available
channels, you must specify the type of signal source that is
connected to the TV (i.e. an Air or a Cable system).
Press the MENU button to display the menu.
Press the ▲ or ▼ button to select Channel, then
press the ENTERE button.
Antenna
Auto Program
Clear Scrambled Channel
Channel List
Fine Tune
Press the ▲ or ▼ button to select Auto Program,
then press the ENTERE button.
Auto Program
Select the Antenna source to memorize.
Air
Cable
Auto
Move Enter
Press the ▲ or ▼ button to select an antenna
connection, then press the ENTERE button.
➢ Air: Air antenna signal.
Cable: Cable antenna signal.
Auto: Air and Cable antenna signals.
Auto Program
Select the cable system.
Analog STD HRC
Digital STD HRC
Start
Move Enter
button to scan
: Air ►
Start
Start
Start
Return
IRC
IRC
Return
2009-09-10 9:51:26