Electrical Installation; Electrical Requirements; Connect Electrical Supply - Thermador Masterpiece Serie Guide D'installation

Model: CET305TB

Electrical Installation

Electrical requirements

You can find the identification plate with the electrical
specifications on the underside of the appliance. The
junction box must be located within 3 feet of the cooktop
connection. It should be easily accessible for service
purposes.
Power supply
Model 240 V AC, 60 Hz
system: circuit
breaker
CEM305TB 40 Amp
CET305TB 40 Amp
CEM366TB 50 Amp
CET366TB 50 Amp
8

Connect Electrical Supply

9
The electrical power supply system should be a 1-phase,
3-wire system with ground connection. Install suitable
junction box (not furnished). An appropriately-sized, UL-
listed conduit connector must be used to correctly attach
the conduit to the junction box.
The branch-circuit breakers ampacity, the wire sizes and
the connections must conform to the requirements of the
National Electrical Code or Canadian Electrical Code and
all local codes and ordinances.
Attach flexible conduit to the junction box.
Metal conduit and leads are factory installed.
9
208 V AC, 60 Hz
system: circuit
breaker
Connect the cooktop lead wires to the junction box
30 Amp
supply wires in proper phase:
30 Amp
black (L1) to black
40 Amp
red (L2) to red
40 Amp
green or blank copper wire to ground
Model: CET366TB
WARNING
Before installing, turn off at the service panel. Lock
service panel to prevent power from being turned
on accidentally.
WARNING
To reduce the risk of electrical shock and fire, do
not use a flexible power-supply cord with this
appliance. Connect only to a 3 wire, 120/240-volt
power supply; the neutral conductor is not required
for the operation of the appliance. The potential at
the power supply electrical connections shall be
150-volts-to-ground or less.