Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
If range does not operate, check the following:
Household fuse is intact and tight; or circuit breaker has not
tripped.
Range is plugged into a grounded outlet.
Electrical supply is connected.
See the "Troubleshooting" section in the Use and Care Guide
or User Instructions.
When the range has been on for 5 minutes, check for heat. If
range is cold, turn off the range and contact a qualified
technician.
If you need Assistance or Service:
Please reference the "Assistance or Service" section of the Use
and Care Guide, or the cover of the User Instructions, or contact
the dealer from whom you purchased your range.
Moving the Range
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death
or serious burns to children and adults.
When moving range, slide range onto cardboard or hardboard to
avoid damaging the floor covering.
If removing the range is necessary for cleaning or maintenance:
For power supply cord-connected ranges:
1. Slide range forward.
2. Unplug the power supply cord.
3. Complete cleaning or maintenance.
4. Plug power supply cord into a grounded outlet.
14
5. Slide range back so rear range foot is under anti-tip bracket.
6. Refer to the "Verify Anti-Tip Bracket Is Installed and
Engaged" section to verify engagement.
7. Check that range is level.
For direct-wired ranges:
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
2. Slide range forward.
3. Complete cleaning or maintenance.
4. Slide range back so rear range foot is under anti-tip bracket.
5. Refer to the "Verify Anti-Tip Bracket Is Installed and
Engaged" section to verify engagement.
6. Check that range is level.
7. Reconnect power.
Publicité
Table des Matières
