Let's Go Aero BikeWing V2 Manuel Du Produit page 5

Continue securing the bike by wrapping the looped end of one (1) Toggle Strap [Q] around the outside bike peddle. Pull
the bike down and inward against the Foam Pads and then tightly secure the cord to one of the available notches into the
Y-Plate [G] using the tightest available toggle ball. [Fg. 14]
NOTE: Secure loose cord or toggle balls by wrapping excess cord around the base of the uprights of the Y-Plate [G] and
to the Toggle Cord itself by wrapping under or through Toggle Strap [Q].
Q
G
[Fg. 14]
WARNING:
OFF ROAD USE:
ALWAYS SECURE BICYCLES USING TWO TOGGLE STRAPS [Q] PER
Wrap one Toggle Strap [Q] around
BICYCLE AS SHOWN FOR OFF ROAD USE.
the Wing [L] and front fork tubing of
the bike, using one Foam Bumper
[Fg. 15]
between the fork and the Wing. Loop
FRONT FORK
the Toggle Strap on itself and secure
TUBING
the Toggle Strap in place by looping
one or more of the toggle balls under
Q
the tensioned cord.
Wrap one Toggle Strap [Q] around
the seat stay tubing on the rear of
L
the bike as shown. Using one Foam
Bumper between the seat stay and
the Wing.
FOAM BUMPERS
SEAT STAY
TUBING
Page 5 of 11