Let's Go Aero BikeWing V2 Manuel Du Produit page 2

STEP 1: INSTALLATION (FOR 1.25IN HITCHES ONLY)
Vehicles with 2in Hitches must skip this step.
Remove the Hitch Adapter [B] from the Shank [A].
[Fg. 1]
STEP 2:
Slide the end of the
Shank [A] into the Hitch
Receiver [Fg. 2 & 3]
STEP 3:
Insert the NoMotion Pin [C] from the passenger side with
the attached Washers [D & E] into the vehicle hitch .
Secure with Retainer Clip [F]. [Fg. 4]
NOTE: For vehicles with 2in Hitch Receivers, the NoMotion
Pin [C] must be inserted from the side of the Shank [A]
where the Hitch Adapter [B] is the thickest.
2in Hitch Receiver
B
[Fg. 2]
1.25in Hitch Receiver
[Fg. 3]
F
[Fg. 4]
Page 2 of 11
B
[Fg. 1]
A
OUTIL REQUIS : CLÉ 3/4"
E
D
C
*2in Hitch Shown
A
A