Service; Blade Care; Off-Season Storage - Yardworks 60-1638-4 Manuel Du Propriétaire

Service

Blade Care

WARNING:
When removing the cutting blade for
sharpening or replacement, protect your hands with
a pair of heavy gloves or use a heavy rag to hold the
blade.
Periodically inspect the blade adapter for cracks, especially if you
strike a foreign object. Replace when necessary. Follow the steps
below for blade service.
1. Disconnect spark plug boot from spark plug. Turn mower
on its side making sure that the air filter and the carburetor
are facing up.
2. Remove the bolt and blade bell support which holds the
blade and the blade adapter to the engine crankshaft. See
Fig. 7-1.
3. Remove blade and adapter from the crankshaft. See Fig. 7-1.
Blade
Adapter
Blade Bell
Support
Figure 7-1
4. Remove blade from the adapter for testing balance.
Balance the blade on a round shaft screwdriver to check.
Remove metal from the heavy side until it balances evenly.
When sharpening the blade, follow the original angle of
grind. Grind each cutting edge equally to keep the blade
balanced.
WARNING:
An unbalanced blade will cause
excessive vibration when rotating at high speeds. It
may cause damage to mower and could break
causing personal injury.
All manuals and user guides at all-guides.com
5.
6.
7.
To ensure safe operation of your mower, periodically check the
blade bolt for correct torque.

Off-Season Storage

The following steps should be taken to prepare your lawn mower
for storage.
•
•
•
•
Blade
•
When storing any type of power equipment in a poorly
ventilated or metal storage shed, care should be taken to
rust-proof the equipment. Using a light oil or silicone, coat the
equipment, especially cables and all moving parts of your lawn
mower before storage.
Bolt
Lubricate the engine crankshaft and the inner surface of
the blade adapter with light oil. Slide the blade adapter
onto the engine crankshaft. Place the blade on the adapter
such that the side of the blade marked "Bottom" (or with
part number) faces the ground when the mower is in the
operating position. Make sure that the blade is aligned and
seated on the blade adapter flanges.
Place blade bell support on the blade. Align notches on the
blade bell support with small holes in blade.
Replace hex bolt and tighten hex bolt to torque: 450 in. lbs.
min., 600 in. lbs. max.
Clean and lubricate mower thoroughly as described in the
lubrication instructions.
Coat mower's cutting blade with chassis grease to prevent
rusting.
Refer to engine manual for correct engine storage
instructions.
Do not use a pressure washer or garden hose to clean your
unit.
Store mower in a dry, clean area. Do not store next to
corrosive materials, such as fertilizer.
7
17