Kohler K-6228 Guide D'installation Et D'entretien page 6

Setscrews
Apply sealant
to the back of
the flange.
Setscrew
4. Install the Spout
NOTE: Anchors are required when installing to materials such as
glass, mirror, and ceramic tile. The anchors and fasteners are not
supplied. Select appropriate fasteners and anchors for the finished
wall material.
If Anchors Are Required
Position the wall flange over the spout plug (not shown) with the
three holes at the 2, 6, and 10 o'clock positions. Mark the hole
locations on the wall.
Drill holes at each of the marks, using the drill bit size and type
appropriate for the finished wall material.
All Installations
Confirm there are three setscrews pre-installed in the wall flange.
Make sure they do not protrude into the inside diameter of the
wall flange. Adjust as necessary using a 3/32" hex wrench.
Apply plumbers putty or other suitable sealant to the back of the
wall flange.
Slide the wall flange over the spout plug (not shown).
Position the three holes on the wall flange at the 2, 6, and 10
o'clock positions, then secure the flange with three wood screws
or other appropriate fasteners (not provided).
Remove the spout plug.
Temporarily place the escutcheon on the wall flange.
1095311-2-J
All manuals and user guides at all-guides.com
Wood Screws
Escutcheon
6
Spout
Kohler Co.