Control Panel - Kenmore 35932 Manuel De L'usager

CONTROL PANEL

FAN SPEED
• Every time you push this button, it advances the setting as follows: {High
Cool
Energy
Saver
Fan
Timer
MODE TIMER
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of
hours until shut-off.
• For your sleeping comfort, once Time is set, the
Temperature setting will raise 1°C after 30 min.,
and once again after another 30 min.
• Push Timer button to advance setting from 1Hour
2Hours ... 12Hours maximum.
- START TIME
• If unit is off, use Timer to set number of hours
before unit starts.
• Push Timer button to advance setting from 1Hour
2Hours ... 12Hours maximum.
MODE
- Push this button to shift mode of operation from COOL
- COOL:
• Fan runs continually for normal cooling operation
- ENERGY SAVER:
• The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on
and the unit will check the room air temperature to determine if cooling is needed.
- FAN:
• Fan-only operation.
AUTO RESTART
When power is restored after an electrical power failure, the unit will begin to run at its last setting.
All manuals and user guides at all-guides.com
OPERATION
°
C
F1 LOW
F2 MED
F3 HIGH
TEMP
FAN
POWER
SPEED
- 14 -
Low Med
REMOTE CONTROL SIGNAL
RECEIVER
TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range
of 60°F°(16°C) to 86°F(30°C) by increments of 11
1°C.
• The setting appears in the display.
POWER
• To turn the air conditioner ON, push this
button.
To turn the air conditioner OFF, push the
button again.
• This button takes priority over any other
button.
• When you first turn it on, the unit is in
cool mode, High fan speed, Temperature
setting at 72°F(22°C) .
ENERGY SAVER FAN.
High}