Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PROCEDURE B
1
Redirect the louvers at the back of the wall
sleeve to 60° angle as shown in the FIG 9. The
use of pliers is recommended.
60°
Rear Louvers
(Top View)
If the wall sleeve already has a rear grille, skip
2
to step 4. If the wall sleeve does not have a rear
grille or louvered panel, install the plastic grille
from the kit. Cut the plastic grille to 25-1/2" wide
and 15-1/4" high. Place the plastic grille to the
inside of the wall sleeve at the rear flange.
Place the plastic grille
Fasten the 4 washer screws to secure the grille
3
to the wall sleeve. If you need plastic nuts to
mount plastic grille to the inside of the wall
sleeve, there are plastic nuts in the installation
kit. The nuts are installed from the inside of the
sleeve and are pressed into the square holes of
the rear flanges.
or
Fasten the screws
All manuals and user guides at all-guides.com
INSTALLATION
7
3 /
"
32
60°
FIG. 9
FIG. 10
FIG. 11
- 8 -
Remove the backing from the Vertical Insulation
4
strip 15
9 / 16
x 1
3 / 8
x 1
3 / 8
inside right of the sleeve as shown below.
Remove the backing from the Around Insulation
strip 67
x 1
x
1 /
3 /
25 /
8
8
32
inside front of the sleeve as shown below.
Around Insulation
Vertical Insulation
Remove the metal rear grille and replace it with
5
the plastic rear grille.
Remove the
metal rear grille
6
If the depth of your existing wall sleeve is less
than or equal to 18", skip to step 7. Otherwise,
cut the baffles and the support blocks according
to length "A" in the table below.
Length "A"
Depth"D" of the existing
wall sleeve (inches)
(inches)
18 D 18-
5
/
8
18-
5
/
D 19-
3
/
8
4
19-
3
/
D 22
4
and attach that to the
and attach that to the
Indoor
Outdoor
9
1
/
"
6"
2
FIG. 12
Plastic rear grille
FIG. 13
A
Support
Block
3
/
4
1-
3
/
Baffle
4
4
A
FIG. 14
Publicité
Table des Matières
