Before Cleaning; Care Of Your Microwave Oven; After Cleaning - Panasonic NN-S262 Manuel D'utilisation

CARE OF YOUR MICROWAVE OVEN

BEFORE CLEANING:

Unplug at socket of the oven. If impossible, leave
oven door open to prevent oven from accidentally
turning on. Do not attempt to clean the Oven Light or
Cooktop/Night Light compartment while plugged in.
Inside of the oven:
Wipe with a damp cloth.
Mild detergent may be
used if the oven gets
very dirty. The use of
harsh detergents or
abrasives is not
recommended.
Oven Door:
* Wipe with a soft cloth when steam accumulates inside
or around the outside of the oven door. During
cooking, especially under high humidity conditions,
steam is given off from the food. (Some steam will
condense on cooler surfaces, such as the oven door.
This is normal.)
* Inside surface is covered with a heat and vapor barrier
film. Do not remove.
Shelf (NN-S262 only)
Clean with a soft damp cloth
to avoid scratches.
Glass Tray:
Remove and wash in warm,
soapy water or in a dishwasher.
Menu Label:
Do not remove. Wipe with a damp
cloth.

AFTER CLEANING:

Be sure to replace the Roller Ring and Glass Tray in
the proper position and press Stop/Reset Pad to
clear the Display Window.
Roller Ring and oven cavity floor:
Wipe the bottom surface of the oven with mild
detergent, water or window cleaner and dry. Roller
Ring may be washed in mild soapy water or in a
dishwasher. These areas should be kept clean to
avoid excessive noise.
- 26 -
Outside oven surfaces.
Clean with a soft damp cloth. Do not
use harsh detergents or abrasives to
avoid scratching the surface. To
prevent damage to the operating
parts inside the oven, water should
not be allowed to seep into
ventilation openings.
Control Panel:
* Covered with a removable
protective film to prevent scratches
during shipping. Small bubbles may
appear under this film.
(Hint - To remove film, apply
masking or clear tape to an
exposed corner and pull gently.)
* If the Control Panel becomes wet,
clean it with a soft, dry cloth. Do
not use harsh detergents or
abrasives on the Control Panel.