Complete The Installation; Using Your Ceiling Fan; Remote Control - LUCCI Air AIRFUSION Instructions

Airfusion Penta Installation Instructions

COMPLETE THE INSTALLATION


Insert the remote receiver into the mouting bracket (Fig. 8)

After completing the electrical wiring at the mounting bracket terminal and connecting the remote
receiver power input wires and fixed wiring via the 4-ports quick connectors (1); connecting remote
receiver power output wires and motor wires via the 4-ports quick connectors (2).

Cover the mounting bracket with the canopy. Ensure all electrical wiring is tucked inside the canopy
and that they are not damaged during this step. Secure the canopy to the hanger bracket using the
screws provided. Fig 9.

REMOTE CONTROL

Your ceiling fan is controlled via the remote control. There are 4 buttons (HI, MED, LOW, OFF) to control
the fan speed and one button to control light on/off. Fig. 12
Before operating the remote, the following must be considered.
-
2 x AAA 1.5V (size) batteries are required to operate the remote control. Remove the battery cover
from the back of the remote and insert 2 x AAA batteries. Ensure the polarities are correct as
shown in the battery compartment. (Batteries not included.)
-
The remote (transmitter) and receiver must be configured so that communication between each
other is paired up. This is achieved by setting the DIP switch on the receiver and remote on the
same setting.
Note: The DIP switch assembly has 4 switches which can be setup to 16 different transmitting code
combinations. This is practical when there is more than 1 remote/receiver pair operating locally or
in the same room.
Note: To access the receiver DIP switches, remove the DIP switch cover.
8 | P a g e

USING YOUR CEILING FAN

Fig. 9
V e r 1 . 0