LUCCI Air AIRFUSION Instructions page 6

Airfusion Penta Installation Instructions
INSTALLING THE DOWN ROD (Fig. 4)
1. Loose the ball joint (2) by removing the set screws (3).
2. Loose the bolt (6) and set screw (7) from the coupling (8).
3. Feed the down rod (4) through the canopy (5).
4. Insert the motor wires (1) through the down rod and secure the ball
joint back to the down rod.
5. Insert the down rod to the coupling; line up the coupling holes with the
down rod holes then insert and tighten the bolt.
6. Finally secure the down rod and the coupling by tightening the set
screw on the coupling.
HANG UP THE FAN (Fig. 5)
1. Lift the fan assembly onto the mounting bracket (1). Fig.5
2. Ensure the notch of the ball joint (3) is positioned on the
stopper of the mounting bracket (2) to prevent the fan from
rotating when in operation.
BLADE ATTACHMENT (Fig. 6)
1. Insert the blade (2) into the square slot of the motor
(1).
2. Secure the blade on the bracket by using 3 motor
screws (3), ensuring
simultaneously.
3. Once completed, repeat the process on the
remaining blades.
LIGHT KIT INSTALLATION (Fig. 7)
1. Remove the screws (3) from the light kit bracket (4).
2. Connect the male and female connector (1) together.
3. Attach the light kit (2) to the light kit bracket (4) and tighten it using the screws (3)
4. Install the globes (not included).
5. Lift and attach the glass to the lamp base and secure it by turning clockwise.
6 | P a g e
they are tightened
Fig. 4
Fig. 5
Fig. 6
V e r 1 . 0