AKASO V50 Pro Mode D'emploi page 9

Effect Setting
1. AE Meter: Center/Average/Spot
Default setting is Center.
In photography, the metering mode refers to the way in which a camera determines
exposure. Cameras generally allow the user to select between center, average or
spot metering modes. The different metering modes allow the user to select the
most appropriate one for use in a variety of lighting conditions.
2. FILTER: Off/Black&White/Sepia/Vivid/Natural/Negative/Warm/Cool/Red/Green/Blue
Default setting is None.
3. White Balance: Auto/Daylight/Shade/Tungsten Light/White Fluorescent
Default setting is Auto.
White Balance lets you adjust the color temperature of videos and photos to
optimize for cool or warm lighting conditions. When you change this setting, the LCD
display immediately shows you the effect on your image.
4. EV: -2.0 / -1.0 / +0.0 / +1.0 / +2.0 (Exposure Value)
Default setting is +0.0.
By default, your camera uses the entire image to determine the appropriate
exposure level. However, Exposure lets you select an area that you want the camera
to prioritize when determining exposure. This setting is particularly useful in shots
where an important region might otherwise be over- or underexposed.
When you change this setting, the LCD display immediately shows you the effect on
your image. If you change modes, the camera returns to using the entire scene to
determine the correct level of exposure.
5. ISO: Auto / 50 / 100 / 200 / 400 / 800 / 1600
Default setting is Auto.
ISO determines the camera's sensitivity to light, and creates a trade-off between
brightness and resulting image noise. Image noise refers to the degree of graininess
in the image. In low light, higher ISO values result in brighter images, but with greater
image noise. Lower values result in lower image noise, but darker images. When you
change this setting, the LCD display immediately shows you the effect on your image.
12
General Setting
1. Control: Mic/Speaker/Brightness
You can adjust the mic, speaker and brightness of your V50 Pro.
2. Sounds: Shutter: ON/OFF
Boot-up: ON/OFF
Beep: ON/OFF
Default setting is on.
You can turn on or off the shutter, boot-up, beep sounds.
3. Distortion Calibration: ON/OFF
Default setting is off.
Turn on Distortion Calibration, it can correct the image distortion.
4. Angle: Super Wide/Wide/Medium/Narrow
Default setting is Super Wide.
The angle refers to how much of the scene (measured in degrees) can be captured
through the camera lens. Super Wide angle captures the largest amount of the
scene, while Narrow angle captures the least.
5. Power Frequency: 50Hz/60Hz
Default setting is 50Hz.
6. Diving Mode: ON/OFF
Default setting is off.
Turn on Diving Mode, it can compensate for the lack of red light in underwater
scenes. Diving Mode is designed to be used in tropical and blue water, optimized for
use between 10 and 80 feet.
7. Wifi: ON/OFF
Default setting is off.
8. RF: ON/OFF (Remote)
Default setting is off.
13