AKASO V50 Pro Mode D'emploi page 13

2
VIDEO
To record Video, verify the camera in Video mode.
To start recording:
Press the Grey Video Button. The camera will emit one beep and the camera light
will flash while recording.
To stop recording:
Press the Grey Video Button again. The camera will emit one beep and the camera
light will stop flashing while recording.
PHOTO
To capture a photo, verify the camera in Photo mode.
To take a photo:
Press the Red Photo Button. The camera will emit a camera shutter sound.
20
Photo Button
Video Button
Splashproof only, not waterproof
CR2032 BATTERY REPLACEMENT FOR REMOTE
1. Use a 1.8mm Phillips tip screwdriver to remove the 4 screws on the back cover of
the remote, allowing you to open it.
2. Remove another 4 screws on PCB board.
3. Lift the PCB board and slide out the battery, as shown in the picture.
Note: Do NOT rotate the PCB board to avoid reversing the camera and video button
functions.
21