De Dietrich DTE410 Serie Guide D'utilisation page 30

All manuals and user guides at all-guides.com
99632082_ML_A.qxd 11/03/04
C
hanging the type of gas supply (cont'd)
A
DJUST THE RETARDER ON THE TAPS
located under the knobs. Proceed as
follows:
• Work on one tap at a time.
• Pull off all knobs and sealing rings.
CHANGING FROM NATURAL GAS TO
THE BUTANE/PROPANE GAS
- Using a small screwdriver screw
fully the brass, adjustment screw
(yellow) (For your model see Fig. 5)
clockwise.
- Check the position of the sealing rings
and knobs before putting them back in
place. Make sure the knobs are pushed
down as far as possible.
CHANGING FROM BUTANE /
PROPANE GAS TO NATURAL GAS OR
TO BUTANE / PROPANE AIR
- Using the small screwdriver, unscrew the
brass, adjustment screw (yellow) ( Fig. 5)
depending on model, anti-clockwise.
- Push the control knob back in position,
light the burner and turn to maximum
power. Then turn the knob back to its low
flame position.
- Remove the knob again then turn the
adjustment screw clockwise as low as
possible without extinguishing the
flames.
- Put back the sealing ring and control
knob then turn it several times from
maximum position to minimum position :
the flame must not be extinguished.
Otherwise, re-adjust it by slightly
screwing or unscrewing the adjustment
screw so that a stable flame is obtained
when the knob is turned from maximum
to minimum position.
- Put the burner heads, covers and pan
supports back in position.
30
14:42 Page 30
Installing your hob in all simplicity
Adjustment
screw
Tap axis
Knob
Sealing ring
Gas tap
Fig. 5