De Dietrich DTE410 Serie Guide D'utilisation page 25

All manuals and user guides at all-guides.com
99632082_ML_A.qxd 11/03/04 14:41 Page 25
Installing your hob in all simplicity
F
itting recommendations (cont'd)
T h e h o b m u s t b e b u i l t i n t o t h e
worktop of a support cupboard.
This worktop must be at least 3
cm thick and heat-resistant or el-
s e c o a t e d w i t h a h e a t r e s i s t a n t
material.
A side-clearance of at least 30 cm
should be left to the right and
left of the hob. A tall cupboard or
partition too close to the hob
would hinder free movement of
kitchen utensils.
If a horizontal partition is put un-
der the hob, it must be placed
between 10 and 15 cm from the
bottom of the work top. In any
case, do not keep any sprays or
pressurized containers in the
compartment which could be just
under the hob.
To prevent any foreign bodies or liquid
Carter
from getting between the hob and the
worktop, stick the foam seal provi-
ded in the wallet in position before
installing the hob. This will also pro-
tect your work surface from the heat
given out by the hob.
1- Remove the pan support grates,
the burner caps and heads after
checking their position.
Seal
2- Turn the hob over and place it
gently over the opening in the work-
top paying attention not to damage
the control knobs and lighters.
3- Stick the foam seal around the
outside of the hob.
4- Put the hob back the right way
up and place the burners, caps and
pan grates back in position.
25