Axis Q8414-LVS Guide D'installation page 13

22. Fold the top of the camera assembly upwards until the camera assembly is pressed
against the entire rim in the back chassis opening.
Important
Adjust the cable slack so that the cables are not squeezed between the sides of the camera
assembly and the back chassis.
23. Attach the camera assembly to the back chassis using the screws (torque 2.5 Nm).
24. Remove the protective film on the front of the camera assembly.
Set up the field of view
Tilt the lens to obtain the optimal field of view that covers as much as possible of the monitored
area.
Maximum Tilt Positions for the Lens
Your tilt position for optimal field of view is found in between the maximum tilt positions.
AXIS Q8414–LVS Network Camera
13
EN