Ametek mocon Dansensor MAP Mix ProVectus Guide Utilisateur page 45

Dansensor MAP Mix Provectus
®
Location Register write Encoding
0x0011 Mix 2 setting
(3-gas mixer
only)
0x0020 "Mixer table 1"
offset values
(write only)
0x0030 "Mixer table 2"
offset values
(write only)
0x0040 Vacuum buffer
set pressure
(Write only)
0x0041 Vacuum buffer
hysteresis
(Write only)
0x0042 Vacuum buffer
min on time
(times 100ms)
(Write only)
0x0043 Vacuum buffer
min off time
(times 100ms)
(Write only)
FR
1 unsigned byte
Range 0 to 100%
Only used when a 3-gas mixer is connected. In case send to a
2-gas mixer, the mixer will return a ACK, but the received
setting is ignored
For a 3-gas mixer this parameter controls the setting of
"GAS 1 INPUT" i.e. %N
2
See "Mix 1 setting" encoding column, how setting of "Mix 2
setting" will change the setting of "Mix 1 setting"
Not used in MMP 
Not used in MMP
4 byte float. Saved in non volatile memory.
Actual set point for the pressure in the vacuum buffer.
Typical 3.0 or 5.0 bars.
4 byte float. Saved in non volatile memory.
Typical 0.3 bar. When buffer pressure reach "Vacuum buffer
set pressure" - "Vacuum buffer hysteresis" the valve is turned
on. When the pressure reaches "Vacuum buffer set pressure"
it is turned off.
Not used in MMP, setting is ignored.
Not used in MMP, setting is ignored.
Guide utilisateur
P/N 300864-H
01/2020
43