Display Codes - PROUSER RFC4500 Mode D'emploi

Fault
This indicator turns on when a fault occurs.
See the table "DISPLAY CODES" for the fault codes F01 - F04.
Full
The battery is fully charged and the charger can be disconnected: Disconnect the charger
from the mains. Disconnect the black and red clips from the terminals of the battery.

DISPLAY CODES

CODES
STANDBY:
The charger is in standby-mode.
CHECK:
The Battery is being checked
charging begins.
VOLTAGE:
The
battery-test-mode.
CURRENT:
The
charging-mode.
FAULT 01
a. No connection to the battery terminal
b. Short circuit in connection
c. Reverse polarity connection
FAULT 02
Charging: A clamp has loosened during
charging. Charging stops and a beep
alarm will be given in 25seconds.
FAULT 03
a) 24V battery applied in 12V charge
b) 12V battery applied in 24V charge
FAULT 04
The battery can't be recovered.
REPAIR:
The charger is trying to repair the battery.
FULL:
The battery is fully charged. A constant
voltage is applied to keep the battery in a
full charged condition.
battery voltage
charging current
mode
mode
before
is displayed in
is displayed in
5
TROUBLE SHOOTING
Recheck and reconnect
clamp to the battery terminal.
Recheck all connections
restart the charging process.
Switch-off and
charger and apply the correct
settings.
The battery is
broken. Consult
manufacture or dealer.
the
and
unplug the
potentially
with battery