Control Panel; Filter Replacement - Pur Line FRESH AIR 200 Manuel D'utilisation

CONTROL PANEL

1
2
3
4
5
1. Air quality indicator light.
2. Filter replacement indicator light.
3. ON/OFF: Press ON/OFF button to turn on the device.
4. Operation mode indicator light.
5. Functions button: Change the fan speed. You can choose auto mode, sleep mode, speed.
6. Negative ions indicator light
7. Light intensity sensor: it adjust brightness according to the surroundings. If ambient light is intense, the
brightness will increase, if not, the brightness of the LEDs will decrease.
SENSORS CLEANING
1. Pull up the cover of dust sensor.
2. If sensor is covered with dust, use vacuum to clean the sensor.
3. Clean the aire quality sensors, the dust inlet and dust outlet with a lightly moistened cotton swab.
FILTER CLEANING
THE FILTERS CANNOT BE WASHED WITH WATER.
1. Take out the filters.
2. Be careful of the filter surface to avoid damage it. Use soft brush or dry cotton cloth to clean the HEPA filter
surface only.
3. Place Active carbon filter under sunshine for 30 mins.

FILTER REPLACEMENT

Filter replacement indicator light will turn into red which is based o a built-in timer when reached the filter life.
When the indicator blinks, it is recommended to replace the filter.
Reset the filter replacement indicator: Set the device to OFF, press the switch button for about 2 seconds, the
light goes off, and the complete the reset process.
FILTER REPLACEMENT PERIOD
(At least 1 time per year)
Replace time will vary depending on the installation location using the method. Replacing the standard time is
one year. If used in heavy polluted place, filter replacement schedule will be 6-9 months.
EN
ON/OFF
Auto
Ma Speed
6
Hi Speed
Mi Speed
Sleep
7
9