Attach The Shoulder Strap - sunjoe SPX-SRL9 Manuel D'utilisation

m
WARNING!
Connect the lance only as much as
necessary for the cleaning job. Remain in full control of the
telescoping pole at all times. Loss of control of the sky lance
could result in possible serious personal injury.
Connect the Nozzles/Adapters
NOTE: We've included one Quick-Connect nozzle to get you
started but use any of your favorite Quick-Connect nozzle tips.
The end extension lance is featured with a standard Quick-
Connect collar that can be connected with nozzles and
adapters. Follow the instructions below to use compatible
nozzles or adapters.
Snap the desired nozzle onto the Quick-Connect collar until it
clicks into place (Fig. 4).
End extension lance
Quick-Connect collar
m
WARNING!
Do not make changes to the nozzle while
the trigger is engaged. Doing so could result in damage to the
pressure washer or injury to the user.
The Quick-Connect collar can only be connected with nozzles
or adapters that are also equipped with the standard Quick-
Connect Tip, such as Sun Joe
(SPX3000-TPS). Visit sunjoe.com or contact the Snow Joe
Sun Joe customer service center at 1-866-SNOWJOE
®
(1-866-766-9563) to purchase this spray tip set.

Attach the Shoulder Strap

The sky lance comes with an adjustable shoulder strap.
The shoulder strap should be installed and adjusted to a
comfortable position before operating.
1. To attach the shoulder strap, attach the buckle of the
shoulder strap to the support bracket as shown (Fig. 5).
Fig. 5
Shoulder strap
Buckle
Support bracket
Fig. 4
"Click"
Nozzle Tip
Quick-Connect Spray Tip Set
®
2. To tighten the shoulder strap, pull down on the loose end
of the strap .
Connect with Pressure Washer
1. Shut off the pressure washer and the water supply.
2. Engage the safety lock on the trigger gun by pushing up
on the safety lock until it clicks into the slot (Fig. 6).
Fig. 6
Slot
Safety lock
3. Press the hose handle rest lock button, and rotate the
hose handle rest to expose the high-pressure hose
connection (Fig. 7).
Fig. 7
Hose handle rest
lock button
NOTE: The hose handle rest is used to protect the hose
and the connection when the sky lance is not in use.
+
®
When leaning the sky lance against a wall during breaks,
stand the sky lance on the hose handle rest so the hose
will not become bent (Fig. 8).
Fig. 8
4. Connect a M22 15 mm pressure hose to the high-pressure
hose connection, thread to secure (Fig. 9).
3
Hose handle rest
Hose handle rest