General Operation - sunjoe SPX-SRL9 Manuel D'utilisation

NOTE: To connect with a M22 14 mm pressure hose, first
attach the included hose adapter to the high-pressure
hose connection, then thread the pressure hose on the
adapter, as shown (Fig. 10).
Fig. 9
Fig. 10
High-pressure hose connection
5. Connect the other end of the pressure hose to the water
outlet of the pressure washer. Turn on the water supply
and start the pressure washer.
Operation
m
WARNING!
To reduce the risk of electrocution, possible
serious personal injury or property damage, spray the pressure
stream in a safe direction away from all electrical devices
and bystanders. Ensure proper connection of all accessories
before starting any cleaning project. Ensure compatibility and
proper fit before using this sky lance. Wear eye protection with
side shields. Risk of fluid injections; do not point at people,
pets, electrical devices or the unit itself. Turn off the pressure
washer before changing or adjusting accessories. For cold
water use only. For outdoor use only – store indoors. Save
these instructions. Refer to them frequently and use them to
instruct other users. If you loan someone this tool, loan them
these instructions also.
m
WARNING!
The sky lance will flex as pressure is added
or lost. Fully understand how the pole moves when adding or
lessening pressure before attempting a cleaning project. If you
are not completely comfortable with the movement of the pole
under changing pressure conditions, do not use this product.
Loss of control of the sky lance could result in possible serious
personal injury.
High-pressure hose
High-pressure
hose connection
High-pressure hose
Hose adapter

General Operation

1. The trigger gun features a safety lock to prevent
unintentional use. To lock, push up the safety lock until it
clicks into place. To unlock, release the safety lock so it
lies in its original position on the trigger (Fig. 11).
NOTE: Always engage the safety lock before moving or
adjusting the sky lance.
Fig. 11
Slot
2. Before working on the cleaning project, test the sky lance
in an area away from the project. Get a feeling of how
the lance will move when the trigger is squeezed. Before
starting, make sure the safety lock is down and in its
original position (Fig. 11), hold the sky lance on the trigger
gun and one soft grip, squeeze the trigger to start
(Fig. 12).
NOTE: The gun will kick back when the trigger is
squeezed and released. Before starting/releasing the
trigger, move the nozzle about 10 feet away from the
cleaning surface and stand stably.
Fig. 12
3. Move to the project area, raise the pole and aim toward
the area to be cleaned. Squeeze the trigger to begin
spraying.
4
Safety lock
Trigger
Soft grip
Squeeze the trigger