Using The Nozzles; Working With Detergents - sunjoe SPX3000 Manuel D'utilisation

Fig. 20
Safety lock
3. Turn the switch to the ON (I) position to start the pressure
washer (Fig. 21).
Fig. 21

Using the Nozzles

Before beginning any cleaning task, determine the best nozzle
for the job. Each of the nozzles has a different spray pattern.
The nozzle patterns are 40˚ (for gentle cleaning), 25˚ (for
all-purpose cleaning), 15˚ (for tough jobs), 0˚ (for spot cleaning
or hard-to-reach areas) and the Soap nozzle (for detergent
application).
m
CAUTION!
NEVER change nozzles without locking the
safety lock on the trigger handle.
m
WARNING!
High-pressure jets can be dangerous if
subject to misuse. The jet must not be directed at persons,
pets, live electrical equipment, or the appliance itself.
This electric pressure washer is equipped with five (5)
Quick-Connect nozzles that easily snap onto the
Quick-Connect collar of the spray wand.
To connect a nozzle to the spray wand:
1. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
2. Engage the safety lock on the trigger handle by pushing
Slot
Fig. 22
Trigger
3. Snap the desired nozzle onto the Quick-Connect collar
ON
Fig. 23
To disconnect a nozzle from the spray wand once the cleaning
job is complete:
4. Turn off the pressure washer and shut off the water supply.
5. Engage the safety lock on the trigger handle by pushing
6. Remove the nozzle by placing your hand over the nozzle
m
the trigger is engaged. Doing so could result in damage to the
pressure washer or injury to the user.

Working with Detergents

When cleaning with the pressure washer, some cleaning tasks
can be solved with water alone, but for most tasks cleaning
with detergent allows for more effective dirt removal.
10
up on the safety lock until it clicks into the slot (Fig. 22).
until it clicks into place (Fig. 23).
Spray wand
Quick-Connect collar
Pull the trigger to release water pressure.
up on the safety lock until it clicks into the slot (Fig. 22).
while pulling back on the Quick-Connect collar.
WARNING!
Do not make changes to the nozzle while
Slot
Safety lock
Nozzle
"Click"