Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Manual mode
Wet suction
♦ The surface filter is never to be
removed during suction.
♦ The paper filter bag and
membrane filter must be removed
whenever wet dirt is sucked up.
♦ The appliance is not switched off
when the container is full when
non-conducting liquids (e.g. drilling
emulsion, oils and greases) are
handled. The filling level must be
checked constantly and the
container must be emptied in good
time.
Fitting rubber lips
Note:
The structured side of the rubber lips
must show outwards.
NT 611 Eco / NT 611 Eco TE
Remove the paper filter bag
Remove the membrane filter
Insert power plug
Switch on the machine and start
using it
Drain the dirty water via the drain
hose
Note:
♦ Power Filter Clean is activated
automatically (hammering noise)
when sucking up water from a full
container.
♦ Clean and dry the surface filter,
electrodes, and container when
finished wet-vacuuming.
Automatic operation
(only NT 611 Eco TE)
Insert power plug of the electric
tool into the vacuum cleaner (3)
Switch on the machine (1)
The standby light illuminates (2)
Note:
♦ The vacuum cleaner is
automatically switched on and off
with the electric tool.
♦ The vacuum cleaner has a starting
delay of approx. 0,5 s and an
after-running time of max. 15 s.
♦ Electric tools of 100 - 2200 W can
be connected.
8
Publicité
Table des Matières
