ARDES AR5M39 Instructions D'emploi page 24

- If the maximum speed (High) is set: the fan operates at maximum speed
on Natural mode for 30 minutes, and then it operates at average speed
on Natural mode for another 30 minutes to finally pass to low speed on
Natural mode. The speed operating light indicators are turned on/off
according to the operating mode.
- If the average speed (Middle) is set: the fan operates at average speed
on Natural mode for 30 minutes and then it operates at low speed on
Natural mode. The speed operating light indicators are turned on/off
according to the operating mode.
- If the low speed (Low) is set: the fan operates at low speed on Natural
mode creating a natural breeze.
Each time is pressed, the MODE button changes the operating mode and
so the light indicators are turned on, on the display.
TIMER
(button present both on the control panel and on the remote control):
while the fan is on, press the button to switch off the fan in a range
between 0, 5 and 7, 5 hours from the programming moment.
Each time you press the button, the time increases with 0, 5 hours. The
timer light indicators are turned on, on the display (0,5H, 1H, 2H, 4H).
The total operating time set before the automatic switching off is given
by the light indicators (for example if all the timer light indicators are on
during the operating time set before the automatic switching off, the total
operating time is given by:
0,5H (0,5 hours)+1H (1 hour)+2H (2 hours)+4H (4 hours)=7,5 hours
The timer light indicators are turned off/ on according to the operating
time remained.
To disable the timer function press the button until all the operating light
indicators are off, or turn off the fan manually by pressing the Off button.
OSC
(button present both on the panel and on the remote control):
press this button to enable the automatic oscillation from right to left.
The relative light indicator is turned on, on the display. To disable the
automatic oscillation, press again the button (the related light indicator is
turned off on the display).
MIST
(button present both on the panel and on the remote control):
press this button to enable the misting. Attention: before enabling this
function make sure there is water in the tank; in case you need to add
water please see the paragraph "HOW TO FILL UP THE TANK" Once the
tank is replaced on the main body of the humidifier, press MIST button to
activate the mist function. The indicator light placed on the control panel
of the humidifier (21) turns on in green color.
24