Changing The Water Filter - Samsung RF4289HB Mode D'emploi

CHANGING THE WATER FILTER

To reduce risk of water damage to your
property DO NOT use generic brands of
WARNING
water fi lters in your SAMSUNG Refrigerator.
USE ONLY SAMSUNG BRAND WATER
FILTER. SAMSUNG will not be legally
responsible for any damage, including, but
not limited to property damage caused
by water leakage from use of a generic
water fi lter. SAMSUNG Refrigerators are
designed to work ONLY WITH SAMSUNG
Water Filter.
The Water Filter status icon on the Home
screen enables you to check the fi lter current
status of the water fi lter.
The Filter icon turns red to let you know when
it is time to change your water fi lter cartridge.
To give you time to get a new fi lter, the red icon comes
on just before the capacity of the current fi lter runs
out. Changing the fi lter on time provides you with the
freshest, cleanest water from your refrigerator.
1. Shut off the water supply. Then, turn the water
fi lter ( 1 ) about 1/4 turn, counter-clockwise.
2. Pull the water fi lter (
• To change the water fi lter more easily,
shut off the water supply valve.
• Sometimes, it is hard to disassemble the water
fi lter because impurities in the water cause it to
stick. If you are having diffi culties, grip the water
fi lter fi rmly and pull it hard.
• When you pull the water fi lter, a little water can
leak from the opening. This is normal.
To minimize the water leaks, keep the fi lter
cartridge horizontal when you pull it.
• To prevent overfl ow, empty the
water tray fi lter ( 3 ) and dry
around of case fi lter ( 2 ).
3. Insert the new fi lter into the fi lter case (
4. Push the fi lter, and then turn it clockwise until it
locks.
DA68-02520B(0.2).indb 77 DA68-02520B(0.2).indb 77
All manuals and user guides at all-guides.com
(Red) (Red)
1 ) from the case fi lter ( 2 ).
2
1
2
3
4 ).
4
• If you are in trouble of
inserting the water fi lter as
high pressure of water, shut
off the water supply valve.
• The locked symbol should be lined up with the
indicator line.
5. When the replacement is done, press and hold
the 'Reset the water fi lter' simultaneously for 3
or more seconds at the center of the screen.
(Refer to the "WATER FILTER" part on this
manual.)
6. If you turned off the water supply, turn it back
on.
For a replacement water fi lter, you can visit
your local home Improvement center or
contact the Samsung Parts distributor.
Be sure the replacement water fi lter has
the SAMSUNG logo on the box and on the
water fi lter.
Link : http://www.samsungparts.com
Removing any residual matter inside the
water supply line after installing the water
fi lter.
1. Turn ON the main water supply and supply
water from water supply line.
2. Run water through the dispenser until the water
runs clear (approx. 6 to 7 minutes).
This will clean the water supply system and
remove air from the lines.
3. Additional fl ushing may be
required in some households.
4. Open the Refrigerator door and
make sure there are no water
leaks coming from the water
fi lter.
Be sure to fl ush the dispenser thoroughly,
otherwise water may drip from the
dispenser. This means that there is still air
in the line.
operating _77
2013.2.28 10:18:38 AM 2013.2.28 10:18:38 AM