Extraordinary Maintenance - Diamond TS 12 Manuel D'utilisation

EXTRAORDINARY MAINTENANCE

For the intervention of extraordinary maintenance, consequent to breaks or revisions or mechanical and electric damages, it
is necessary an intervention request directly to the Authorized Assistance Center.
The instructions about the extraordinary maintenance don't appear in the present instruction manual for the use and so
must be explicitly requested to the manufacturer.
CLEANING
It is forbidden to clean by hand the organs and the elements in motion.
All cleaning interventions must be started only and exclusively, after having unloaded the machine with the
food product in working and having insulated from the electric feeding source and from external energy.
The machine, the electric equipment and the machine board components must not be ever washed utilizing
water, and not in any kind of jets form and quantity; so, without "bucket" nor "rubber" nor "towel". Don't
put ever directly the machine in the sink or under the tap.
The machine hygiene level classification and the associated equipment, for the foreseen use, is 2 (two): machine that, after
an hygiene risk evaluation, is in conformance with applicable international standards requirements, but requests a programmed
disassembly for the cleaning.
FREQUENCY PERSONNEL
Operator
At the end of every
shift work and
however before the
daily use
All the surface and the machine parts destined to come in contact with the food product or with
the food zones (hopper internal surface, machine neck and the grinding group, the pestle) and the
jets zones (machine external surface) must be cleaned and disinfected with the under reported
modalities. For the grinding group disassembly activities see the previous descriptions.
Scrape the surfaces from the possible food product residuals (for example with plastic
scrapers);
Clean all the food zone surfaces and jets zone with a morbido dampened clothes (not
draining) with detergent diluted in hot water (also common soap for dishes is good). Don't
soak them. With a towel clean inside the grinding mouth. Use specific products for steel,
which must be liquids (not in cream or pastries however abrasive) and above all must not
contain chlorine. Against the fat substances the denatured alcohol.
Rinse with cleaned hot water and successively dry all food zone surfaces and jets zone
with soft clothes that don't lose coats.
The parts in steel stainless of the grinding group can be washed also in dishwasher.
The grinding group re assembly must happen only after a working requirement, leave the
pieces wrapped in a dry soft clothes that doesn't lose coats.
PERIODS OF LONG INACTIVITY
During the machine long inactivity periods provide to pass vigorously on all steel surfaces
(especially if stainless) a clothes soaked of Vaseline oil so that to spread a protective veil.
THINGS DA NON FARE BEFORE OR DURING THE CLEANING:
Enter towards the moving elements without to be previously checked of their stop;
Enter towards the moving elements without have stopped it in safety stop (blockage in zero
position of the electric feeding sectioning devices)
PRODUCTS NOT TO USE:
Compressed air with jets towards the zones with flour warehouses and in general towards the
machine;
Vapor equipment;
Detergent that contains CLORO (also if diluted) or its compounds as: the bleach, the muriatic
acid, products to clear the drain, products for the marble cleaning, in general decalcifying, etc
... can attack the steel composition, staining and oxidizing it unavoidable. The only above
described products fumes can oxidize and in any case corrode the steel;
Steel wool, brushes or abrasive discs produced with other metals or alloys (ex. Common steel,
aluminum, brass, etc...) or tools that have previously cleaned other metals or alloys, that
except to scratch the surface.
Detergents in abrasive dust;
Fuel, solvents or inflammable and/or corrosive fluids;
Substances used to clean the silver.
MODALITY
Pag.
15
di
18