Problem
You cannot open the
appliance door.
The appliance makes
an unusual noise.
The cycle is shorter
than the time displayed.
The cycle is longer than
the time displayed.
The washing results are
not satisfactory.
You cannot set an op‐
tion.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
14. TECHNICAL DATA
Dimension
Electrical connection
Level of protection against ingress of solid parti‐
cles and moisture ensured by the protective cov‐
er, except where the low voltage equipment has
no protection against moisture
Possible solution
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the
drum.
Make sure the levelling of the appliance is correct. Refer to
'Installation'.
Make sure that the packaging and/or the transit bolts are
removed. Refer to 'Installation'.
Add more laundry in the drum. The load may be too small.
The appliance calculates a new time according to the laun‐
dry load. See the 'Consumption Values' chapter.
An unbalanced laundry load increases the duration time.
This is a normal behaviour of the appliance.
Increase the detergent quantity or use a different deter‐
gent.
Use special products to remove the stubborn stains before
you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Make sure that you press only the wanted button(s).
Width/ Height/ Depth/
Total depth
Voltage
Overall power
Fuse
Frequency
600 mm/ 850 mm/ 517 mm/ 576
mm
230 V
2200 W
10 A
50 Hz
IPX4
ENGLISH
23