Using The Detergent And Water Softener; Adjusting Salt Consumption - Samsung DW60H3010FV Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Using the detergent and water
softener
WATER SOFTENER
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would have a detrimental
or adverse effect on the operation of the appliance. The higher the content of these minerals and salts, the
harder your water is. The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.

Adjusting salt consumption

The dishwasher is designed to allow for adjusting the amount of salt consumed based on the
hardness of the water used. This is intended to Spelling - optimise - customise the level of salt
consumption so that the salt consumption could be set proceed as follows:
1. Switch on the appliance;
2. Press the Start button for more than 3 seconds to start the water softener set model within
60seconds after the appliance was switched on;
3. Press the Start button to select the proper set according to your local environment, the sets
will change in the following sequence: H1  H2  H3  H4  H5  H6; It is recommended
that adjustments should be made in accordance with the following table.
* The manufactory setting: H4 (EN 50242)
4. Wait for 5 seconds to end the set up model.
WATER HARDNESS
º dH
º fH
0-5
0-9
6-11
10-20
12-17
21-30
18-22
31-40
23-34
41-60
35-55
61-98
1 dH (German degree) = 0.178 mmol/l
1 Clark (British degree) = 0.143 mmol/l
1 fH (French degree) = 0.1 mmol/l
Contact your local water board for information on the hardness of your water supply.
WATER SOFTENER
The hardness of the water varies from place to place. If hard water is used in the
dishwasher, deposits may form on dishes and utensils. The appliance is equipped with a
special softener that uses a salt specifically designed to eliminate lime and minerals from the
water.
Selector Position
DW60H6050
series
º Clark
mmol/l
DW60H5050
series
0-6
0-0.94
H1
7-14
1.0-2.0
H2
15-21
2.1-3.0
H3
22-28
3.1-4.0
H4
29-42
4.1-6.0
H5
43-69
6.1-9.8
H6
Salt
consumption
DW60H3010
(gram/cycle)
series
Express
ECO
Express, ECO
Intensive
Intensive, Express
Intensive, ECO

Using the detergent and water softener _21

Autonomy
(cycles/1 kgs)
0
/
20
60
30
50
40
40
50
30
60
20

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dw60h3010fwDw60h5050fwDw60h5050fsDw60h6050fwDw60h6050fs

Table des Matières