Using The Detergent And Water Softener; Adjusting Salt Consumption; Water Hardness - Samsung DW-FN320T Manuel D'utilisation

Using the detergent and water
softener
WATER SOFTENER
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would have a detrimental
or adverse effect on the operation of the appliance. The higher the content of these minerals and salts, the
harder your water is. The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.

Adjusting salt consumption

The dishwasher is designed to allow for adjusting the amount of salt consumed based on the
hardness of the water used. This is intended to Spelling - optimise - customise the level of salt
consumption so that the salt consumption could be set proceed as follows:
1. Switch on the appliance;
2. Press the Start/Pause button for more than 3 seconds to start the water softener set model
within 60seconds after the appliance was switched on;
3. Press the Start/Pause button to select the proper set according to your local environment,
the sets will change in the following sequence: H1->H2->H3->H4->H5->H6; It is
recommended that adjustments should be made in accordance with the following table.
* The manufactory setting: H4 (EN 50242)
4. Wait for 5 seconds to end the set up model.
º dH
0~5
6~11
12~17
18~22
23~34
35~55
1 dH (German degree) = 0.178 mmol/l
1 Clark (British degree) = 0.143 mmol/l
1 fH (French degree) = 0.1 mmol/l
Contact your local water board for information on the hardness of your water supply.
WATER SOFTENER
The hardness of the water varies from place to place. If hard water is used in the
dishwasher, deposits may form on dishes and utensils. The appliance is equipped with a
special softener that uses a salt specifically designed to eliminate lime and minerals from the
water.
DD81-01446D-03_EN.indd 11 DD81-01446D-03_EN.indd 11

WATER HARDNESS

º fH º Clark mmol/l
0~9 0~6 0~0.94
10~20 7~14 1.0~2.0
21~30 15~21 2.1~3.0
31~40 22~28 3.1~4.0
41~60 29~42 4.1~6.0
61~98 43~69 6.1~9.8
Salt consumption
Selector Position
(gram/cycle)
H1 0
H2 20
H3 30
H4 40
H5 50
H6 60

using the detergent and water softener _11

Autonomy
(cycles/1 kgs)
/
60
50
40
30
20
2013-07-02 2013-07-02 2:15:19 2:15:19