Assembling Your Cleaner; Using Your Cleaner; Dry Vacuuming - Hoover DINAMIS S 9040 Manuel D'utilisation

AsseMBLInG YoUR cLeAneR

Remove all components from the packaging.
1. Remove the castors from inside the tank, by releasing the securing latches to
access the tank. turn the tank upside down and attach the castors into the holes.
2. connect the hose by inserting the hose connector to the product with the arrow
towards the top, then rotate clockwise until locked.

UsInG YoUR cLeAneR

1. ensure the product is correctly assembled together with the securing latches.
2. Assemble the accessories you require for the specific task.
3. The product is operated by switching the on/off switch (H).
4. to adjust the performance the suction regulator can be adjusted
suction regulator open = reduced performance
suction regulator closed = maximum performance
5. Adjust the floor nozzle to match the surface you are cleaning

dry Vacuuming

notE: After wet vacuuming, the appliance must be absolutely dry.
1. Ensure the pre-motor filter is fitted correctly.
with damaged filters.
2. Ensure the dust bag is fitted correctly.
3. when the product looses suction, stop vacuuming and check the bag and replace
if necessary.
Wet Vacuuming (model specific)
notE: never use a dust bag when vacuuming liquids
1. When the product float valve activates and looses performance, please stop
vacuuming and empty the tank. Prolonged use after this time may cause
damage.
2. Always empty and dry the product after use.
Dinamis im-4langs.indd 5
Never dry vacuum without filters or
5
gB
[1]:
[2].
29/10/2008 10:59:27