Assembling Cleaner - Hoover TurboPOWER WindTunnel Mode D'emploi

1. Assembling cleaner

This cleaner was inspected and packaged carefully before being shipped from the factory.
If you should happen to need assistance during assembly or operation,
Visit us online at www.hoover.com to find the service outlet nearest you (click on
the "Service" button) OR
Call 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only)
OR
Call 1-330-499-9499 to speak with a representative in our Consumer Response Center.
Carton contents
1-1
A
Empty carton. Find the parts shown
before disposing of packing materials.
A. Handle section
B. Cleaner body
C. Hose, cleaning tools and wands
D. Crevice wand (included with some
models instead of crevice tool)
E. Handle bolts and nuts packet
(in bag with owner's manual)
STEP 1 Attach handle
1-2
A
Remove bag door on cleaner body
by pushing down at top of door and
pulling door outward.
Switch (A) above bag door should
be in OFF position.
C
B
1-3
Slide handle onto cleaner body.
Not
E
D
1-4
Push bolts into holes on back of
handle.
Continued
3