Mounting The Hood Body - ROBLIN Dune XLS Manuel D'instructions

• Drill ø 8 mm holes at all the centre points marked.
• Insert the wall plugs 11 in the holes.
• Fix the brackets using the 12a screws (4,2 x 44,4) supplied.
• Fix the back panel (where present) using the 12a (4,2 x 44,4) screws supplied.
• Before hooking up the hood body, adjust the
two screws Vr located on the hood body
connection points so that they are at the half
way point.
• Hook the hood body to the mounted bracket.
• Adjust the screws Vr to level the hood body.
• Tighten the lock screw Vf.
When installing the ducted version, connect the hood to the chimney using either a flexible or rigid
pipe ø 150 or 120 mm, the choice of which is left to the installer.
• To install a ø 120 mm air exhaust connection,
insert the reducer flange 9 on the hood body
outlet.
• Fix the pipe in position using sufficient pipe
clamps (not supplied).
• Remove any activated charcoal filters.
GB

Mounting the hood body

Connections
DUCTED VERSION AIR EXHAUST SYSTEM
Vf
Vr
ø 150
9
ø 120
15